[3DMakerWorld] CNCdrive Ethernet Motion Controller + Breakout Board (AXBB-E)

Description

Key Features:
Complete motion controller and breakout board solution in a single board
8 optically isolated high speed N-channel power mosfet transistor outputs.(NPN)
9 non-isolated buffered TTL outputs to control step/dir signals, laser driver etc.
Isolated charge pump output with power N-channel mosfet transistor.
6 high speed optoisolator inputs.
The AXBB-E is a motion controller and breakout board combination with ethernet interface. The device can communicate with a connection to the control computer's network card. The connection can be built with direct connection or via router/switch devices in a local area network (LAN).
The device can be used to control machine tools with stepper or servo motor controls with step and direction interfaces. The controller can output a maximum of 400kHz stepping frequency and can work with up to 6-axes, however only 8 dedicated step and direction signal pins for 4 axes are wired out on the board, but the I/Os on the software side are freely configurable to any pins making it possible to use all 6 axes if required.
Item Specifics
Maximum Output Stepping Frequency: 400kHz stepping
LED indicators on isolated I/Os.
Isolated I/Os are 24Volts capable.
One safety charge pump circuit with isolated output.
2 analog input channels which can work with externally connected potentiometers (not included)